Toilet Installation FAQ

Common problems and solutions of toilet installation

Question 1: after the toilet is installed, can not stand against the wall?

This is related to the selection of the toilet drain distance and the distance of the reserved blowdown pipe from the wall. Some toilet sewage discharge distance from 210mm, 305mm, 400mm three specifications. Under normal circumstances, allow the installation of size 190-210mm, 285-305mm, 380-400mm, that is to say the toilet back, 20mm away from the wall clearance, the purchase should be based on home reserved sewage pipe actual distance from the wall size control, allows the selection of toilet installation size specifications. If the sewage pipe from the wall distance is dead and not standardized, without proper drainage from the toilet when the choice, can buy 1 shifters to adjust. Shifter generally can increase or decrease the maximum distance of the center about 100mm.

Question two: how do you maintain the back of the toilet with a high back?

Toilet parts because of the more complex, and the use of high frequency, affected by water quality and so on. Generally install angle valve, hose, filter, to facilitate the daily maintenance of the toilet. Normally the inlet angle valve is mounted on the side of the toilet and 200mm high above the ground. For this kind of high back toilet, the angle valve is installed on the back of the toilet and is blocked by the toilet after installation. In order to facilitate maintenance, manufacturers in production, taking into account these reasons, usually in the lower part of the toilet, there are maintenance holes. Maintenance can enter the internal switch from the maintenance hole inlet angle valve, or from the upper part of the water tank to the water tank cover is opened or removed to repair, the complete set of product maintenance.

Question three: toilet drain button, press down, can not play or loose, why?

This is related to the quality of the product. It can not be played because the spring is not elastic and loose because it is not locked. Regular manufacturers of buttons, in the warranty period and the number of required use does not occur in this case. But some manufacturers of poor quality of production, the number of times and shelf life will be relatively short.