Posts

How Removing Deep Stains?

/in /by

Mix 1 part baking soda with three parts water. Combine the baking soda with the water in a small bowl or cup. Continue to mix it together until the baking soda absorbs the water and forms a paste. If your paste is too thick, add more water to it. If the paste is too runny, add more baking soda.


Apply the paste to the stains. Wear gloves and use your hands to smear a good portion of the paste over the stains on your shower. Target any discoloration or built up mildew that you weren’t able to remove from a basic cleaning. Cover the paste with plastic wrap. Tape the ends of the plastic wrap so it stays in place.


Don’t cover all the edges in tape so that the marble can breathe. Let the paste sit on your shower for 24 hours. The paste will dry and absorb the stain under it. When the paste is ready, it should be dry and hard. Remind people in the house that you are doing a deep cleaning and that they won’t be able to use the shower.


Rinse and wipe down the baking soda. Remove the baking soda paste from your shower by rinsing down your shower and wiping the stained areas with a rag. If you notice that the stain is still visible, repeat the steps until it is fully removed. Clean your screen with saliva. Saliva contains enzymes and bacteria that literally consume the dirt on the shower screens.


This is useful if you want to clean a spot where dirt is concentrated. Use a bleach solution to remove any mildew or mold. Mix ⅓ cup (80 ml) of bleach with 1 gallon (3.79 L) of water. Wear gloves and scrub the bathtub and the edges where the caulk used to be with the solution. Make sure that the room is well-ventilated. Use a stiff scrubbing brush to scrub the bathtub with bleach.

How Mixing Your Cleaning Solution?

/in /by

Pour ⅓ cup (79 milliliters) of liquid dish detergent into a spray bottle. The dish detergent will cut through the oils and grease that make up your soap scum, making it easier to wipe away the stuck on grime. You can use any dish detergent that is formulated to cut through grease. If you use too much detergent in your cleaning solution, it will not ruin your cleaner; however, the cleaning solution will be harder to wash away.

Measure out 1 cup (237 milliliters) of white vinegar. In addition to attacking bacteria and mildew, white vinegar is great for clearing away soap scum and lime deposits. While the smell may be off-putting, it evaporates away once the vinegar dries. If the smell of the vinegar really bothers you, try adding a few drops of a pure essential oil, such as lemon or orange oil.

Heat your vinegar in the microwave. Set the timer for 1 minute to warm the vinegar. Warm vinegar is easier to mix than cool vinegar, so it will help you create a better cleaning solution. You don’t need to boil your vinegar. Depending on the strength of your microwave, you may want to warm your vinegar in 30 second intervals to make sure that it reaches a slightly warm temperature rather than getting too hot or not getting warm enough.

Add the vinegar to the spray bottle and mix. Blend the two ingredients using a swirling motion. Continue moving the bottle until they are completely blended. Avoid shaking the bottle because it will cause excessive sudsing. Your end result should be a slightly foamy substance that is lightly tinted the color of your detergent.

You can increase or decrease the quantity of cleaner that you prepare by adjusting the amount of the ingredients as long as you maintain the 3 to 1 ratio of white vinegar to detergent. If you’d prefer, there are several non-abrasive commercial options available that are safe for fiberglass. Check the label to make sure that the product does not contain abrasive cleaning agents or bleach.

bathtub cleaning and maintenance of four skills

Bathtub Cleaning And Maintenance Of Four Skills

/in /by

bathtub cleaning and maintenance of four skills

Tip 1: pour warm water into the tub to 2 inches above the top of the nozzle, or leave the water in the bath after use. Add two teaspoons of low foam to the water: powder, automatic dish, detergent and a small amount of household bleach. Turn on the Jacuzzi for 5 to 10 minutes, then close, drain the water, and then rinse the bathtub surface with water. Bathtubs are hot and humid for a long time. They also breed a lot of bacteria. Sometimes they are clean and the surface looks clean. In fact, there are still a lot of bacteria. China Cleaning network recommends regular use of water to wipe the surface of the bathtub, do not casually use disinfectant water, because disinfection water may not be able to kill mold and fungi.

2 Tips: moderate surface stains can use soft bristled toothbrush dipped in waste bleach water cleaning surface, can remove stains, can eliminate mildew:. Have to wipe besmirch, also can use half a lemon dipped in salt scrub brush, toothpaste can also be coated with a function with a soft bristled toothbrush, turpentine at this time is to use. For scale, the toilet bowl is usually a good product. If you don’t like the pungent flavor, you can use lemon and white vinegar as a more natural way. Do not use a cleansing agent with a fading function, especially when the bath tub is in color. For mold and fungal diseases, rinse with bleach, water, and peroxide immediately.

Skills 3: timely repair scars, bathtubs installed, do not move without permission, need to move the location, you must contact professionals. Do not strike or hit the surface with hard objects, causing bumps or scratches. If you need to repair a dull or scratched part, use a clean cloth, mix it with a colorless, automatic grinding solution, wipe it vigorously, and then coat it with a colorless protective wax. Please do not stay in the regional waxing, to prevent slipping.

Tip 4: deal with the pipe blockage at any time and disinfect the pipe on time. Clean it up once or twice a week, and then, two, prevent bacteria from growing. : you can use special cleaning sewer products, into the sewer, 5 minutes after cleaning, be careful not to use in the metal pipe. If the bath is blocked, can be the first to water valve closed, and then put the right amount of tap water in the bathtub; a rubber suction device (toilet use) placed in to water valve; in the open water valve, water overflow muffle basin or bath; and then quickly to attract, suck out dirt or hair cleaned in time. In the case of serious congestion, you can repeat it several times until it’s clear.