Posts

How Removing Your Existing Tub?

/in /by


Cut a panel behind your tub to access the drain pipes. Most times, the water supply valve for your tub is located in the walls behind the faucet. Go into the room adjacent to your bathroom to cut a hole in the wall where the drain and faucets are for your tub. Use a stud finder so you don’t accidentally cut into one of the studs. Cut an 8 in × 8 in (20 cm × 20 cm) square in the drywall with a reciprocating saw to expose the pipes.


If you can’t access the room adjacent to the drain, cut a hole in the floor beneath the bathroom using a reciprocating saw. Make sure you’re underneath where the tub drains. Wear safety glasses while working with your saw. Turn off the water supply to your bathroom. The water supply for your tub is either controlled by a valve in the wall behind your faucet or by the main water pump. Turn the valve so it’s perpendicular to the pipes to turn it off.


If your valve shut-off is circular, look for the directions printed on the valve head to figure out which way to turn it. If you cannot turn off the water for your tub or bathroom, you may need to turn it off for the entire home or building.


Remove the tub spout. Locate the screw on the underside of the faucet or where it connects to the wall. Use a flathead or Phillips screwdriver to remove the screw. If it doesn’t have a screw, tighten the jaws of a pipe wrench around the back of the faucet and twist it counterclockwise until it’s loose. Then, pull it out. If you want to save the faucet, put a rag in between it and the wrench so you don’t leave any scratches.


Take out the main and overflow drains. A drain removal tool is a cylinder that fits into the drain to loosen its connection to the pipes. Put the end of a drain remover tool in the drain hole and turn it counterclockwise. Keep turning the tool until the drain is loose and you can pull it out by hand. Unscrew the overflow drain, located on the front wall of your tub, and pull it off of the surface.

How Preventing Bathroom Mold?

/in /by

Turn the bathroom fan on when the bath or shower is in use. A bathroom fan is very effective at reducing the humidity in the room. Turn the fan on when you start running the bath or the shower and keep it on for at least 5 minutes afterward to help clear the steam. If possible, try to keep the fan on until all of the steam is gone. Open the window and turn the fan on to reduce the humidity the most effectively.

Open the window after you have a bath or a shower. Mold grows faster when there are high humidity and water levels, such as when the bath or shower are used. Open the window straight after using the bath or shower to let the excess water evaporate and the steam escape. Keep the window open until the bathroom is dry. Try to remember to open the window every time to limit mold growth.

Dry all of the surfaces if you are worried about the moisture levels. Although regular cleaning and keeping the bathroom well-ventilated should be effective at keeping mold at bay, sometimes these precautions aren’t enough. If you find a spot in your bathroom where mold keeps returning, use a cleaning cloth to dry it whenever there is excess water. Some common mold areas may include the basin or the shower tiles. You can use a squeegee instead of a cloth on tiles and glass doors.

Use rubber gloves whenever you are working with mold. Keep yourself safe by not touching mold with your bare hands. If you are using vinegar or Borax to clean the mold, regular household rubber gloves are fine. However, if you are working with bleach, choose natural rubber or PVC gloves instead. Take the gloves off as soon as you are finished cleaning so that the spores don’t spread throughout your home.