Posts

How Removing Your Existing Tub?

/in /by


Cut a panel behind your tub to access the drain pipes. Most times, the water supply valve for your tub is located in the walls behind the faucet. Go into the room adjacent to your bathroom to cut a hole in the wall where the drain and faucets are for your tub. Use a stud finder so you don’t accidentally cut into one of the studs. Cut an 8 in × 8 in (20 cm × 20 cm) square in the drywall with a reciprocating saw to expose the pipes.


If you can’t access the room adjacent to the drain, cut a hole in the floor beneath the bathroom using a reciprocating saw. Make sure you’re underneath where the tub drains. Wear safety glasses while working with your saw. Turn off the water supply to your bathroom. The water supply for your tub is either controlled by a valve in the wall behind your faucet or by the main water pump. Turn the valve so it’s perpendicular to the pipes to turn it off.


If your valve shut-off is circular, look for the directions printed on the valve head to figure out which way to turn it. If you cannot turn off the water for your tub or bathroom, you may need to turn it off for the entire home or building.


Remove the tub spout. Locate the screw on the underside of the faucet or where it connects to the wall. Use a flathead or Phillips screwdriver to remove the screw. If it doesn’t have a screw, tighten the jaws of a pipe wrench around the back of the faucet and twist it counterclockwise until it’s loose. Then, pull it out. If you want to save the faucet, put a rag in between it and the wrench so you don’t leave any scratches.


Take out the main and overflow drains. A drain removal tool is a cylinder that fits into the drain to loosen its connection to the pipes. Put the end of a drain remover tool in the drain hole and turn it counterclockwise. Keep turning the tool until the drain is loose and you can pull it out by hand. Unscrew the overflow drain, located on the front wall of your tub, and pull it off of the surface.

How Keeping Your Drain in Good Condition?

/in /by

Keep trash out of the sink drain. Perhaps the most important part of keeping your drain clean is being mindful of what you put in it. This is especially true for bathroom sink drains, which will inevitably accumulate natural detritus, such as hair. As a rule of thumb, if you’re unsure whether it’s okay to go down the drain, throw it away instead.

Avoid washing dishes or disposing of any food products in the bathroom sink. Don’t dispose of personal care products, such as cotton balls, dental floss, or bits of toilet paper in the sink drain. Take care not to let the small round liner underneath the lid of personal care products go down the drain.

Use less soap and other products. Even soap and other things that you regularly dispose of in your bathroom sink, such as toothpaste and shaving cream, can contribute to build up in your drain. As such, get in the habit of using smaller amounts of these products.

A small dollop of toothpaste is plenty, and a single pump of hand soap is sufficient to wash your hands. Let the water run down the drain for a few seconds after using soap or toothpaste so it gets flushed away.

Avoid commercial drain cleaners. There are a lot of reasons not to use commercial drain cleaners that rely on chemicals. They can corrode your pipes and damage other components of your fixtures and plumbing system. They are also toxic, and can work their way into the ground water in your area.