Posts

How Submerging the Shower Head in Vinegar?

Disconnect the shower head from the shower. Check the instruction manual of your shower if you do not know how to do this. Many shower heads will simply twist off, but yours may be different. If you have recently installed a new shower head, and it has a warranty, make sure you handle it according to package instructions.

Pour white vinegar in a tub. Find a container or tub large enough to fully submerge your disconnected shower head. Pour enough white vinegar into the tub to completely immerse your shower head. Pour some baking soda into the tub. You should pour in about ⅓ of a cup of baking soda for every cup of vinegar that you pour into the tub. The solution should bubble.

Put the shower head in the tub of vinegar. Completely immerse your shower head in the tub of vinegar. Make sure that it will stay submerged for at least an hour. Wait one hour. Leave your shower head soaking in the vinegar. You can also leave your shower head there overnight, if you want more of a deep clean.

Rinse the shower head. Pour water from the sink onto your shower head. Rinse off the excess vinegar and wipe clean with a cloth. Turn on your sink faucet. Allow a strong stream of water to go through the pipe attachment into the nozzle. Let it run for 30 seconds. Reconnect the shower head. Turn on your shower. Let your shower run for a few minutes to get rid of any vinegar that might still be inside the shower head.

Wipe off excess sealer on the surface of your shower. Use a dry absorbent cloth to remove any excess sealer that pools on the top of your shower. Any excess sealer that’s pooled on the surface of your marble or that has not been absorbed must be removed for the health and appearance of your marble, as leftover sealer can stain it.

How Keeping Bathroom Grout Clean?

Wipe it with alcohol. One of the easiest ways to prevent grout from getting dirty is to clean it often with something that will prevent mold and mildew from forming in the first place. One such substance is alcohol. Once a week, wipe the grout down with isopropyl (rubbing) alcohol using a clean cloth.

Spray it with a mold inhibitor. There are several spray solutions you can make yourself using a clean spray bottle, including vinegar and water, tea tree oil and water, and hydrogen peroxide. Two to three times a week, spray the grout after a bath or shower with a solution of:

Half-and-half vinegar and water. However, be aware that overuse of vinegar on grout can cause erosion over many years. Water and 15 to 20 drops of tea tree oil. Shake well before each use. Pure hydrogen peroxide in a spray bottle.

Dry the grout after every use. Removing the excess water from tiles and grout after a shower or bath is one of the easiest ways to keep grout looking new. After each use, wipe the shower walls or bath down with an old towel or squeegee.

Keep the bathroom dry. Another great way to keep mold and mildew from growing in your bathroom is by removing the water that allows it to grow. If your bathroom isn’t equipped with an exhaust fan, remove moisture from the air after every shower or bath by opening the window and blowing a stand-up fan out the window.

Seal the grout. Grout should be re-sealed every few years. Sealant can be applied to the grout lines with a paint brush. Allow it to dry, and then remove sealant from the tiles by wiping them in a diagonal direction with a damp cloth or sponge. One applied and cleaned, allow the sealant to cure for about three to four hours.