Entries by admin

How Using Commercial or Homemade Cleaners?

/in /by

Clean soap scum with a commercial glass cleaner if you have it. Spray a little bit of the cleaner on a small area of your shower door, then wipe it off with a clean cloth. If this “test spray” works, repeat this process on the rest of the shower door to clean all the soap […]

How to Install a Bathtub?

/in /by

Installing a bathtub is a complex job that shouldn’t be attempted by novices. However, if you have some plumbing and construction experience, this may be a DIY project that you feel comfortable tackling. If you’re looking for a starting point, this guide provides an outline of the job. If you’re unsure what to do at […]

How Securing the Tub and Surround?

/in /by

Set the tub in place and level it. Carefully position the tub in the alcove so that the drain rests over the drain opening in the floor. Place a level on each side of the tub. If any spots are uneven, position hardwood shims underneath the tub and glue them in place. Some manufacturers may advise […]

How Fitting the New Tub and Installing the Drain?

/in /by

Select a tub that will fit in the designated space. Measure the length and width of the alcove where you will install the tub. Also, measure the height and width of your bathroom doorway to make sure the tub will fit through the bathroom door! Take your measurements to a home improvement store to guide […]

How Removing the Old Bathtrub?

/in /by

Turn off the water at the main line. The first step is to shut off the water for the bathroom you’ll be working in. Locate the main line and turn it all the way off. Then, turn on the faucet in your tub to drain the lines. Remove the accessories and disconnect the water lines. […]

How to Paint the Bathtub?

/in /by

If your cast-iron tub is looking a little rundown, save some money and give it a new coat of paint rather than replacing it. After filling in any gaps or cracks, sanding down the interior and exterior, and giving it a few coats of acrylic urethane enamel paint, you’ll have a bathtub that looks brand […]

How Applying the Paint?

/in /by

Tape protective sheets on the walls and floor. Before you paint, use masking or painters tape to secure plastic sheeting to the walls surrounding the tub, as well as to the floor underneath the tub. You may also want to lay plastic sheeting over any other fixtures, like the toilet or sink, and remove decorations, […]

How Filling Gaps and Sanding the Tub?

/in /by

Prepare the epoxy putty before applying it to any cracks. Wear rubber gloves to protect your skin, and read the manufacturer’s instructions before you begin. Open up the putty and tear or cut off a small section of the putty. Work the putty between your fingers until it is pliable, kind of like how you […]

How Bleaching the Bathtub?

/in /by

Open windows or bring in a fan before you begin working with bleach. If your bathroom is small and doesn’t have a vent or windows, bring in a fan to blow air out as you work. The most important thing is that you’re getting fresh air so you aren’t just breathing in bleach fumes. You […]

How Removing the Caulk?

/in /by

Use a caulk-removing tool and isopropyl alcohol to clear away the caulk. Apply the isopropyl alcohol to the caulk via a spray bottle or blot it on with an old washcloth—this softens the caulk and makes it easier to remove. Use your caulk-removing tool to scrape away as much of the caulk as you can. […]